Referral and Testimonial. If you are still about to have your dream house built and this is your first time to hire someone for a plumbing plan, then getting referrals is the best option. In addition to families and friends, one great source of referrals is real estate professionals as they are always in contact with water quality for plumbing plans and repairs.
If you find that the water line repair leak is in the supply line you will need to replace it or simply tighten it. Start by turning the water supply off and then flushing the toilet to get rid of the excess water. Now use the towels to dry the area so that it is easier for you to fix the leak. Use a wrench to loosen the hexagonal nuts on the supply line at the main end as well as the one which goes to the flush tank. Now use the replacement supply line which you have and tighten the bolt at the supply end first. Now adjust the length that you will need for the pipe to reach the flush tank. Once you adjust the length use a knife to cut the extra length and then tighten the hexagonal bolt at the other end.
A c clamp or hose clamp is use full for securing or holding the rubber used to seal leaks on piping. However, a clamp should be used carefully considering the type of pipe being repaired, clamping too tight will fracture the pie leaving you with a bigger problem than you started off with.
10) Tighten down the closet bolts making sure NOT to use too much torque. You aren't installing tires on a race car here so, take it easy Mr. Goodwrench. You just want to hold the toilet in place, not crack the porcelain base of the toilet or damage the drain flange.
Be certain that the bathroom exhaust fan vents to the outdoors, not into the house or attic. If the exterior vent dampers don't operate properly or water line repair don't seat well have them fixed or replaced.
And the way to know what's sufficient? Well, until the work is done an the bill paid you won't know for certain, but this is the best that can be suggested and normally works very well.
Is your garbage disposal clogged, but it is turning ok? This may be due to a blockage in the pipe. If you look at the pipe work under your sink you will see that the disposal is connected to a pipe that should join to a U bend and providing it was installed correctly it should have a connector that can be undone. If you undo this connector the pipe will pull away and generally this is where most blockages occur. Remove the blockage and reconnect the pipe.